Your furnace is an integral part of your home. Without one, you wouldn’t be able to stay warm during cold weather. Yet furnaces can have some issues that are more typical than others.

Let’s go over these issues and discuss what they might cost to correct so you know before you call an HVAC technician. Some of the most common furnace repair problems involve:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. Furnace Won’t Turn On

There are a couple of reasons why your furnace won’t turn on, so make sure to check all of them.

  • Is your thermostat set right? Make sure it’s on “heat,” “auto” and that your desired temperature is higher than the room’s current temperature. If you use a programmable thermostat, make sure it has new batteries.
  • Is the circuit breaker tripped? Your furnace can’t operate if it doesn’t have electricity. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch found on or close to it. Because this switch looks like a light switch, it’s easy to unintentionally turn it off. If it was off, it might take your furnace a few minutes to start.
  • Is the air filter clean? A dusty air filter can cause a lot of problems for your furnace. Replace yours if you can’t see light through it.

Estimated Repair Cost

This problem can be complex, so the estimated cost to repair it varies according to what’s wrong.

2. Furnace Won’t Stay Lit

Your furnace follows a certain sequence when it begins heating your home.

  1. Your thermostat detects the temperature has fallen and tells your furnace to start running.
  2. The draft inducer fan activates to pull in fresh air for combustion.
  3. The gas valve unlocks for the burners, which are lit electronically.
  4. The flame sensor tells your furnace the burners have been ignited.

If something is off during the sequence, your furnace will shut down as a safety precaution.

A couple of possible causes for this problem include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t sense a flame, it will turn off your furnace to prevent natural gas from spilling into your home. The ignition process corrodes flame sensors as time passes. While cleaning during annual furnace maintenance can help, yours may ultimately need to be replaced.
  • Bad limit switch. This safety feature will turn off your furnace if it detects backdrafting. Backdrafting is hazardous, because carbon monoxide and natural gas can leak into your home. These switches can malfunction due to age, damage or dust buildup.
  • Old thermostat. If your thermostat isn’t working correctly, your furnace won’t be able to run.
  • Dirty air filter. A dirty air filter can reduce airflow and cause your furnace to shut down to avoid overheating. Make sure to replace yours every 30 to 90 days, or anytime you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s necessary to note yours may fluctuate based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. Furnace Won’t Blow Hot Air

In many cases, this problem is linked to a wrong thermostat setting or a dusty air filter that’s restricting airflow. Use the steps above to fix the problem.

4. Furnace Won’t Turn Off

If it’s extremely chilly outside or you like your home to be toasty, your furnace may be working for a long time.

If this isn’t what’s happening, make sure your thermostat is set correctly and running properly. If your fan setting is at “on,” the blower motor will be running even when the furnace isn’t, so it’ll seem like your furnace is running all the time.

Alternatively, there might be a problem with the blower motor or your ductwork may be leaking air, forcing your furnace to run continuously to make up for the air loss.

Estimated Repair Cost

These costs are estimates, so it’s important to note yours may be different based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on house size

Ambient Air Can Resolve Your Furnace Issues Quickly and Affordably

Furnace issues can be a costly headache, but not when you call Ambient Air. We’ve been delivering the quality, affordable furnace repair Tucson homeowners have relied on since {year}. Call us at 520-357-4912 to receive your free estimate today.